GRAPHITE 59G071 Manual Del Usuario página 14

TRANSLATION OF THE ORIGINAL INSTRUCTIONS
NOTE: BEFORE THE POWER TOOL IS USED FOR THE FIRST TIME, READ THIS INSTRUCTION MANUAL AND
KEEP IT FOR FUTURE REFERENCE.
WARNING! Read all warnings and guidelines for safe operation. Failure to observe recommendations
given in the following warnings and guidelines regarding safety of operation may cause danger of electric
shock, fire and/or serious injuries.
Detailed safety regulations regarding operation of the straight grinder.
Safety guidelines regarding safety.
This power tool can be used as a grinder. Observe all safety guidelines, instructions, descriptions
and data provided with the power tool.
Failure to observe the following recommendations may cause danger of electric shock, fire and/or
serious injuries.
This power tool is not suitable for sanding with abrasive papers and wire brushes, as well as for
polishing and abrasive cutting.
Do not use equipment, which is not designed and recommended by the manufacturer specifically
for this device.
The fact that it can be fastened to the power tool, does not guarantee safe operation.
The permissible rotational speed of a working tool used cannot be lower than the maximum
rotational speed given on the power tool.
A working tool rotating faster than the permissible speed may break and its parts may chip off.
The outside diameter and thickness of a working tool must correspond to dimensions of the
power tool. A working tool of incorrect dimensions may not provide sufficient control over the power
tool.
After a working tool is changed or any adjustments are made, make sure the collet is properly
tightened. A loosened collet nut may result in loss of control over the tool, while a loosely fastened
rotating elements may be suddenly projected.
Under no circumstances should damaged working tools be used. Before each use, grinding tools
should be checked for cracks, abrasion or heavy wear. When the power tool or a working tool
is dropped, it must be checked for damage or another, undamaged tool should be used. If a
working tool is checked and fastened, the power tool should be switched on for a minute at the
highest speed, paying attention so that the operator and bystanders are beyond the reach of the
rotating tool. Damaged working tools often break during this testing period.
Always wear personal protective equipment. Depending on a type of work, a full face mask, eye
protection or safety glasses should be worn. A dust mask, ear protection, protective gloves or
a special apron protecting against small particles of abrasive material and workpiece should
be worn, if needed. Protect your eyes against airborne foreign bodies occurring during operation. A
dust mask and protective mask for the respiratory system must filter dust produced during work. The
influence of noise for a longer period of time may lead to deterioration of the hearing.
Always make sure bystanders are in a safe distance from the power tool reach zone. Each person
in the vicinity of the power tool must wear personal protective equipment. Workpiece chips or
broken working tools may chip off and cause injuries also beyond the direct reach zone.
When works are performed, during which the power tool may encounter hidden electric
conductors or own power cord, the power tool should be held by the isolated surfaces of the
handle. A contact with the power mains network may transfer voltage onto metal parts of the power
tool, which may result in electric shock.
The power cord must be kept away from the rotating working tools. When the control over the tool
is lost, the power cord may be cut or caught, and your hand or the entire arm may get into the rotating
working tool.
STRAIGHT GRINDER
59G071
DETAILED SAFETY REGULATIONS
14