Removing And Installing Blades - DeWalt DCS374 Manual De Instrucciones

FIG. 5
S
FUEL GAUGE BATTERY PACKS (FIG. 6)
Some D WALT battery packs include a fuel gauge which consists of
e
three green LED lights that indicate the level of charge remaining in
the battery pack.
The fuel gauge is an indication of approximate levels of charge
remaining in the battery pack according to the following indicators:
75–100% charged
51–74% charged
< 50% charged
Pack needs to be charged
To actuate the fuel gauge, press and hold the fuel gauge button (T).
A combination of the three green LED lights will illuminate designating
the level of charge left. When the level of charge in the battery is below
the usable limit, the fuel gauge will not illuminate and the battery will
need to be recharged.
R
FIG. 6
T
NOTE: The fuel gauge is only an indication of the charge left on the
battery pack. It does not indicate tool functionality and is subject to
variation based on product components, temperature and end-user
application.
For more information regarding fuel gauge battery packs, please
contact call 1-800-4-D WALT (1-800-433-9258) or visit our website
e
www.dewalt.com.

Removing and Installing Blades

WARNING: To reduce the risk of serious personal injury,
turn tool off and remove the battery pack before making any
adjustments or removing/installing attachments or accessories.
An accidental start-up can cause injury.
CAUTION: Cut Hazard. Blade tension lever is under spring
pressure. Maintain control of lever when releasing blade tension.
TO REMOVE BLADE (FIG. 2, 4)
1. Rotate the blade tension lever (I) clockwise until it stops to
release tension in blade (refer to Figure 2).
2. Turn the saw over and place it on a workbench or table with the
handle to the right.
3. Begin removing the blade at the upper portion of the blade guard
(O) and continue around the pulleys (N). When removing the blade,
tension may be released and the blade may spring free. SAW
BLADES ARE SHARP. USE CARE IN HANDLING THEM.
13