Cleaning And Maintenance; Cleaning; Replacing The Trimming Assembly - Grizzly ERT 450/8 Traducción Del Manual De Instrucciones Original

UK
Long grass should be cut at layers from top
to bottom. Use the edge of the protective co-
ver or the spacer bow to maintain the correct
distance.
Cleaning and
maintenance
Always disconnect the plug from
the mains socket before working
on the trimmer.
Any work that is not described
in these Instructions must be
carried out by a servicing agen-
cy authorized by us. Only use
original parts and be very care-
ful with the line cutter during in-
stallation work. Danger of injury!

Cleaning

Do not jet water onto the trimmer
and do not clean it under flowing
water. This would result in the
danger of an electric shock and
the trimmer could be damaged.
Always keep the trimmer clean. Do no
use cleaning agents and solvents.
• After the work has been completed
remove all grass and soil from the cut-
ting device and the protective cover.
• Ensure that the ventilation slots are
always clean and free of grass.
• Clean the trimmer with a soft brush or
a cloth.

Replacing the trimming assembly

Never manipulate the cutting de-
vice by inserting worn out original
112
or alien parts. Only use original
spare parts. Never use metal lines.
The use of alien parts can result in
serious personal injury and cause
irreparable damage to the trimmer
and the guarantee will become
instantly null and void.
Exchanging the line spool:
1. Disconnect the plug from the
mains socket.
2. Turn over the trimmer so that the
cutting head (11) is facing up-
wards.
3. Simultaneously press the two
locks on the cutting head (11)
and remove the hood (18).
4. Remove the line spool (19) from
the cutting head.
5. Insert the new spool with the
smooth side facing upwards in
the cutting head and thread the
two lines through the line eyelets
(20). Ensure that the line ends
do not slip out of the spool slots.
6. Return the hood.(17) Ensure that
the locks of the hood are accura-
tely inserted in the correspondi-
ng recesses of the cutting head.
They lock in audibly.
7. Press the retaining head (17),
release it again and pull the ends
of the cord out a little. Repeat this
process until the ends of the cord
project a little beyond the cord cut-
ter).
Check the string cutter. Do not use
the appliance without a string or
with a defective string. Contact our
nearest Service Centre in case the
string cutter is damaged.