Water Filter Status - Thermador KBUIT4255E Manual De Uso Y Cuidado

WARNING
Cut Hazard
Use a sturdy glass when dispensing ice.
Failure to do so can result in cuts.
3. Press a sturdy glass against the ice dispenser lever. Hold the
glass close to the dispenser opening so ice does not fall
outside of the glass.
IMPORTANT: You do not need to apply a lot of pressure to
the lever in order to activate the ice dispenser. Pressing hard
will not make the ice dispense faster or in greater quantities.
4. Remove the glass to stop dispensing.
NOTE: The first few batches of ice may have an off-flavor
from new plumbing and parts. Throw the ice away. Also, take
large amounts of ice from the ice bin, not through the
dispenser.
Water Dispenser
If you did not flush the water system when the refrigerator was
first installed, press the water dispenser bar with a sturdy glass or
jar until you draw and discard 6 qt (5.7 L) or approximately 3 to
4 minutes of water after water begins dispensing. It will take 2 to
3 minutes for the water to begin dispensing. The water you draw
and discard cleans the system and helps clear air from the lines.
Allow several hours for the refrigerator to cool down and chill
water.
IMPORTANT: Depending on your model, the small removable
tray at the bottom of the dispenser is designed to catch small
spills and allow for easy cleaning. There is no drain in the tray.
The tray can be removed from the dispenser and carried to the
sink to be emptied or cleaned.
To Dispense Water:
1. Press a sturdy glass against the water dispenser lever.
2. Remove the glass to stop dispensing.
NOTE: Water may have an off-flavor if you do not use the
dispenser periodically. Dispense enough water every week to
maintain a fresh supply.
8
Dispenser Light
The dispenser area has a light. It can be turned on or off manually
by pressing the ON or OFF button.
When you use the dispenser the lever will automatically turn the
light on.
NOTE: See the "Changing the Light Bulbs" section for
information on changing the dispenser light bulb.
Dispenser Lock (on some models)
The dispenser can be turned off for easy cleaning or to avoid
unintentional dispensing by small children and pets.
To Lock and Unlock the Dispenser:
NOTE: The lock feature does not shut off power to the
refrigerator, to the ice maker, or to the dispenser light. It simply
deactivates the dispenser levers.
1. Press the LOCK button. The ice and water dispensers will not
work.
2. Press the UNLOCK button. Then, continue to dispense ice or
water as usual.
Wa t e r F i l t e r S t a t u s
The water filter status display will help you know when to change
the water filter. The display is located at the top of the refrigerator
compartment.
A new water filter should display a reading of 99%. The reading in
the display will decrease as the filter life is used. When the
display reads 10%, it is time to order a replacement water filter. It
is recommended that you replace the filter when the filter display
changes to 0% OR when water flow to your water dispenser or
ice maker decreases noticeably. See "Changing the Water Filter"
later in this section.
After changing the water filter, press and hold RESET for
2 seconds until the status display changes to 99%.