Troubleshooting; Accessories; Disposal - Festool DOMINO XL DF 700 EQ Manual De Instrucciones Original/Lista De Piezas De Repuesto

DF 700 EQ
GB
Observe the following instructions:
X
To ensure constant air circulation, always
keep the cooling air openings in the hous-
ing clean and free of blockages.
X
Clean the guides
deposits.
10

Troubleshooting

Fault
Burns
Dowel hole too narrow.
DOMINO dowel cannot be
jointed.
Widening of the dowel hole
with 8 mm cutter
Splinters at edge of dowel
hole
Dowel hole not parallel to
workpiece edge
Tool cannot be loosened dur-
ing tool change
The positions of the dowel
holes which are created with
one of the left and one of
the right stop pins do not
match precisely.
DOMINO joining machine
operates irregularly, jerks
11

Accessories

Use only original Festool accessories and
Festool consumable material intended for
this machine because these components are
designed specifically for the machine. Using
accessories and consumable material from
other suppliers will most likely affect the
quality of your working results and limit any
warranty claims. Machine wear or your own
personal workload may increase depending
on the application. Protect yourself and your
machine, and preserve your warranty claims
by always using original Festool accessories
and Festool consumable material!
The order numbers of the accessories and
tools can be found in the Festool catalogue or
on the Internet under "www.festool.com".
18
[3-1] and [3-6] of dust
Cause
Blunt cutter
a.Blunt cutter
b.Deposits (e.g. chippings in
the dowel hole)
Routing depth too large
(larger than 50 mm)
Excessive feed rate
Workpiece has shifted during
processing
Spindle lock not functioning
The stop pins are selected
different on the right and
left.
a.No dust extractor connect-
ed
b.Rubber buffer
X
Oil the guides regularly and lightly with
resin-free oil (e.g. sewing machine oil).
L We recommend an annual inspection and/
or a check after approx. 100 operating
hours at an authorised customer service
workshop. This is for the safety of the
user and the value stability of the power
tool.
Solution
Use sharp cutter
a.Use sharp cutter
b.Remove deposit and work
with dust extractor
Reduce routing depth
(max.50 mm)
Reduce feed rate
Secure workpiece properly
Twist spindle against the tool
using an open-ended spanner.
If this occurs several times
contact the after-sales service
department.
Select the same stop pins on
the left and the right.
a.Connect dust extractor
b.Replace rubber buffer (spare
[1-1] worn part)
Festool provides comprehensive accessories
which allow you to use your machine effec-
tively and for diverse applications, e.g.:
• Handrail fence RA-DF 500/700
• Cross stop QA-DF 500/700
• Stopper LA-DF 500/700
Assembly instructions are included at the
end of the operating manual.
12

Disposal

Do not throw the power tool in your house-
hold waste! Dispose of machines, accesso-
ries and packaging at an environmentally re-
sponsible recycling centre. Observe the valid
national regulations.