Tabla De Contenido; Original Operating Manual 1 Symbols; Technical Data; Machine Features - Festool DOMINO XL DF 700 EQ Manual De Instrucciones Original/Lista De Piezas De Repuesto

Original operating manual
1 Symbols ..................................
2 Technical data ..........................
3 Machine features ......................
4 Intended use............................
5 Safety instructions ....................
6 Operation ................................
7 Settings...................................
8 Working with the machine ..........
9 Service and maintenance ...........
10 Troubleshooting ........................
11 Accessories ..............................
12 Disposal ..................................
13 Warranty .................................
14 EU Declaration of Conformity......
The illustrations specified are located at the
beginning and end of the operating manual.
1 Symbols
Warning of general danger
Risk of electric shock
Read the Operating Instructions/
Notes!
Wear ear protection.
Wear a dust mask.
Wear protective gloves.
Disconnect from the power supply!
Burning risks from hot surfaces!
Do not throw in the household waste.
2

Technical data

Joiner
Power
Speed (no load) n
0
Routing depth
Routing width, max.
13
13
13
13
14
14
15
17
17
18
18
18
19
19
DF 700 EQ
720 W
21000 rpm
15 - 70 mm
16,5 mm + Ø cutter
Joiner
Ø cutter, max.
Connecting thread of the
drive shaft
Weight (excluding cable)
Safety class
3

Machine features

[1-1] Rubber buffer
[1-2] Stop pins
[1-3] Handles
[1-4] On/Off switch
[1-5] Display for dowel hole width
[1-6] Adjusting lever for dowel hole width
[1-7] Slide for routing depth adjustment
[1-8] Snap button for routing depth adjust-
ment
[1-9] Marker for routing depth adjustment
[1-10] Unlocking of motor unit/guide frame
[1-11] Selection slide for routing height
adjustment
[1-12] Clamp lever for routing angle adjust-
ment
[1-13] Button for releasing stop pins
[1-14] Clamp lever for routing height adjust-
ment
[1-15] Extractor connector
[1-16] Spindle lock
[1-17] Mains power cable
4

Intended use

The machine is intended to create DOMINO
dowel connections in hard and soft wood,
chipboard, plywood and fibreboard. All appli-
cations beyond this are regarded as unin-
tended use.
The machine is designed and approved for
use by trained persons or specialists only.
The user bears the responsibility for
damage and accidents caused by im-
proper use.
DF 700 EQ
GB
DF 700 EQ
14 mm
M8 x 1
5,2 kg
/II
13