Changing Tools; Settings; Setting The Mortise Depth - Festool DOMINO XL DF 700 EQ Manual De Instrucciones Original/Lista De Piezas De Repuesto

Connecting and detaching the mains power
cable [1-17] see Fig. [2].
The switch [1-4] is an on/off switch (I = ON,
0 = OFF).
X Peel off the protective film from the bot-
tom of the guide frame [3-4].
X
Remove the transport safety device
18].
7

Settings

WARNING
Risk of injury, electric shock
X
Always pull the plug out of the socket be-
fore performing any type of work on the
machine!
7.1 Electronics
The machine features full-wave electronics
with the following features:
Smooth start-up
The electronically controlled smooth start-up
ensures that the machine starts up jolt-free.
Constant speed
The motor speed remains constant through
electronic control to ensure a uniform cutting
speed even when under load.
Temperature cut-out
The machine power supply is limited and the
speed reduced if the motor exceeds a certain
temperature. The machine continues operat-
ing at reduced power to allow the ventilator
to cool the motor quickly. If the machine
temperature exceeds the maximum permit-
ted value for longer periods, the machine
switches off completely after approx. 40 sec-
onds and can only be switched on again once
the motor has cooled sufficiently.
Restart protection
The integral restart protection prevents the
machine from automatically starting up
again after an interruption in power when the
machine is used in continuous operating
mode. In this case the machine must be
switched off and then switched back on
again.
7.2

Changing tools

Hot and sharp tools
Risk of injury
X
Wear protective gloves!
[1-
Removing the tool
X
Lift the unlocking device
dibly disengages using the open-ended
spanner [3-3]
X Separate the motor unit
guide frame [3-4].
X Press and hold the spindle lock [4-1].
X
Loosen the cutter
ended spanner
X
Release the spindle lock [4-1].
Inserting the tool
Risk of injury
X Before inserting a new cutter ensure that
the machine, the guide frame and the
guides [3-1]
X
Remove any contamination that may be
present.
X
Only use sharp, undamaged and clean
tools.
X
Press and hold the spindle lock [4-1].
X
Use the open-ended spanner
screw on the cutter [4-3].
X Release the spindle lock [4-1].
X
Slide the guide frame
tor unit [3-5]
7.3

Setting the Mortise Depth

Cutter can come out at the rear side of
the workpiece.
Risk of injury
X Set the routing depth at least 5 mm less
than the workpiece thickness.
X Press one or two snap buttons [1-8].
X Set the slide for the routing depth setting
[1-7]to the desired routing depth (15 - 70
mm).
DF 700 EQ
CAUTION
[3-2] until it au-
supplied (SW 12).
[3-5]
[4-3] using the open-
[4-2] and remove.
WARNING
and [3-6] are clean.
[3-4] onto the mo-
until it audibly engages.
WARNING
GB
from the
[4-2] to
15