Tabla De Contenido - Metra 99-6538B Instrucciones De Instalación

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

INTERFACE FEATURES
• Provides accessory power (12-volt 10-amp)
• Retains R.A.P. (retained accessory power)
• Retains the factory personalization menu and climate controls status
• Provides NAV outputs (parking brake, reverse, and V.S.S)
• Pre-wired ASWC-1 harness (ASWC-1 sold separately)
• Retains the factory backup camera
• Retains the factory AUX-IN jack
• Retains safety chimes
• Ability to add an aftermarket backup camera
• Can be used in amplified or non-amplified models
• Retains balance and fade (non-amplified models only)
• Micro "B" USB updatable
ATTENTION! The rear-view camera input is used to display the climate control status
and personalization menu. If the aftermarket radio does not have a screen with a
rear-view camera input, then there will be no visualization of the climate controls status
and personalization menu, which makes adjusting the climate control impossible. An
externally mounted screen could be substituted in this situation.
AXXESS INTERFACE INSTALLATION
INTERFACE COMPONENTS
• Axxess interface
• 6538 harness
• 18-pin harness with stripped leads
• 4-pin harness with stripped leads
TABLE OF CONTENTS
Connections to be made ..........................................................................................................6-8
- For models without a factory amplifier . ............................................................................. 6-7
- For models with a factory amplifier . ................................................................................... 7-8
Installing the interface . ................................................................................................................9
Initializing the interface . ..............................................................................................................9
Final assembly ..............................................................................................................................9
Screen operation . ........................................................................................................................ 10
Climate control status . .................................................................................................................11
TOOLS REQUIRED
• Wire cutter • Crimp tool • Solder gun • Tape • Small flat-blade screwdriver
• Connectors (example: butt-connectors, bell caps, etc.)
5
REV. 8/16/2017 INST99-6538B

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido