Other Functions
You can also control the unit with a rotary
commander (optional).
Labelling the rotary
commander
Depending on how you mount the rotary
commander, attach the appropriate label as
shown in the illustration below.
D S P L
M O D E
S O U N D
32
S O U N D
M O D E
D S P L
Using the rotary
commander
The rotary commander works by pressing
buttons and/or rotating controls.
You can also control an optional CD/MD unit
with the rotary commander.
By pressing buttons
(the SOURCE and MODE buttons)
(SOURCE)
Each time you press (SOURCE), the
source changes as follows:
Tuner t CD t MD*
* If the corresponding optional equipment is
not connected, this item will not appear.
Pressing (MODE) changes the operation
in the following ways:
• Tuner: FM1 t FM2 t FM3 t MW t LW
• CD unit: CD1 t CD2 t ...
• MD unit*: MD1 t MD2 t ...
* If the corresponding optional equipment is
not connected, the item will not appear.
(MODE)