Installation To Wood Stud Wall - PEERLESS Paramount PA760 Instalación Y Ensamblaje

Installation to Wood Stud Wall

• Make sure that the supporting surface will safely support the combined load of the equipment and all attached
hardware and components.
• Tighten screws so that wall plate is firmly attached, but do not overtighten. Overtightening can damage the screws,
greatly reducing their holding power.
• Never tighten in excess of 80 in. • lb (9 N.M.).
• Make sure that mounting screws are anchored into the center of the studs. The use of an "edge to edge" stud finder
is highly recommended.
• Always use an assistant or mechanical lifting equipment to safely lift and position the flat panel screen.
• hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs.
Installers are responsible for providing hardware for other types of mounting situations.
Wall mount (A) can be mounted to two studs that are 12" - 16" (30 - 41 cm) apart. Using a stud finder, locate
1
and mark the edges of the wood stud used in mounting this product. Use of an edge to edge stud finder is highly
recommended. Use a level to draw a vertical line down the center of the studs. Use a level to draw a horizontal line
5 - 3/16" (132 mm) above the desired screen center to locate the center points of the top mounting slots as shown
in figure 1.1. Use wall plate as a template, level wall mount and mark center of four mounting holes along vertical
lines. NoTe: Be sure arms of wall mount (A) are fully extended to access slots. Drill four 5/32" (4 mm) dia. holes
2.5" (64 mm) deep. Attach wall mount (A) to wall using four 2.5" wood screws (C) as shown in figure 1.2.
NoTe: Flanges of adapter plate indicate top of mount.
Skip to step 2 on page 6.
STUD
fig. 1.1
5 - 3/16"
(132 mm)
CS
WALL PLATE
CS = CeNTer Of SCreeN
ArMS Of wALL MOUNT (A)
NOT ShOwN fOr CLArITy
WARNING
fLANge INDICATeS
TOP Of MOUNT
fig. 1.2
A
C
wOOD
STUD