Setting Up The Coupler - Stryker 1288010000 Manual Del Usuario

Setting Up the Coupler

1. Attach the coupler to the camera head.
• Grasping the rear adapter, screw the coupler onto the camera head (clockwise) until
it forms a tight seal.
Before each use, check the outer surface of the endoscope to ensure there are no
rough surfaces, sharp edges, or protrusions.
Caution When attaching or removing the coupler, grip only the rear adapter, as twisting
other parts of the coupler may result in mechanical damage.
Do not overtighten the coupler, as this may damage the front window of the
camera.
Do not overtighten a direct-coupled C-mount scope, as this may damage the
front window of the camera.
Note: For direct-coupled C-mount scopes (scopes that require no coupler), thread the endoscope
directly into the camera head until it forms a tight seal.
18