Blaupunkt 5CG 22010 Manual De Montaje Y Modo De Empleo página 54

(b)
6. Open the refrigerator door as wide as
possible.
7. Insert the door drivers (b) into the guide
rails of the elbows (a).
8. Use the screws (e) to screw the door
drivers (b) to the edge of the cabinet
door at a distance of approx. 18 mm.
9. Close the door of the built-in cabinet
and check whether the sliding guide
between the elbow (a) and the door
driver (b) functions properly. If
necessary, correct the position of the
door driver.
10. A gap of at least 6 mm must remain
between the refrigerator and the built-in
cabinet door to allow the refrigerator
door to close properly. To set the gap
width, unscrew the screws (e) a little
and manually set the desired distance.
18 mm
90°
18 mm
11. Open the refrigerator door as wide as
12. As a covering, place the short cover
13. Cut the joint profile (f) to a matching
14. Replace the glass shelves (8) and
You have successfully installed the refrigerator.
Start-up
Then screw the screws (e) tight again.
possible and insert the long cover
strips (c) into the guide rails of the door
drivers (b).
strips (d) on the elbows (a).
length. Press it in
refrigerator and the built-in cabinet wall
on the opposite side of the door hinges.
(9), vegetable drawers (7) and door
shelves (4) to (6).
Page 54
(c)
(d)
between the