Troubleshooting Table - Blaupunkt 5CG 22010 Manual De Montaje Y Modo De Empleo

Troubleshooting table

Faults can occur with any electrical appliance. Such faults are not
necessarily defects in the appliance. For this reason, please use the
table to verify whether you can remedy the fault.
WARNING
Risk of electrical shock due to improper repair!
Never attempt to repair a defective – or supposedly defective – appliance
yourself. You may thereby put yourself and future users at risk. Only
authorized specialists may carry out these repairs.
Problem Possible cause
Compressor off, Socket without electricity.
interior lighting
off.
Power plug loose.
Compressor off, Temperature regulator (3)
set
interior lighting
to "0".
on.
The desired temperature
has been reached.
Excessive The temperature regulator is
refrigeration in the set too high.
appliance.
Insufficient The temperature regulator
refrigeration in is set too low.
the appliance.
The door is not closed
tightly or the door seal is
not making full contact
everywhere.
The appliance is located in
the vicinity of a source of
heat.
Warm food stored in the
appliance.
Too many goods placed in
freezer.
Thick layer of ice in the
freezer compartment.
The ambient temperature
is too low or too high.
The compressor appears to
be defective.
Troubleshooting
table
Solutions, tips, explanations
Check the socket with another device.
Make sure the power plug is inserted
correctly.
Turn the temperature regulator to a higher
position (see "Setting the temperature" on
page 40).
Additional refrigeration is unnecessary.
If the internal temperature rises, the
compressor switches on automatically.
Select a lower setting (see "Setting the
temperature" on page 40).
Select a higher setting (see "Setting the
temperature" on page 40).
See "Inspecting and cleaning the door
seals" on page 46.
Place an insulation panel between the
appliance and the heat source or change
the location.
Only store cooled food.
Place a maximum of 2 kg in the freezer at
one time.
Defrost the freezer compartment (see
"Defrosting and cleaning the freezer
compartment" on page 47).
Adjust the ambient temperature to the
climate class (see "Data sheet" on
page 59).
Set the temperature regulator to "7". If the
compressor does not switch on within an
hour, notify our service
(see page 263).
Page 56
department