SATA jet 1000 A RP/HVLP Instrucciones De Servicio página 134

Operating Instructions SATA Automatic Gun
EN
Dismantle the air distribution ring
Attention!
The air distribution ring is fitted firmly in the nozzle head, which can be
damaged if excessive force is used. Injuries can be caused if the SATA
extraction tool slips during use.
→ Wear protective gloves.
→ Always use the SATA extraction tool pointing away from your body.
→ Pull the air distribution ring evenly out of the nozzle head.
• Perform the steps to remove the nozzle set (see chapter 10.1).
• Remove the air distribution ring
.
[9-2]
• Check sealing surfaces for damage and soiling, clean or replace if
necessary.
Fit new air distribution ring
• Insert the air distribution ring [10-3] in the nozzle head [10-2]. The pin
on the bottom of the air distribution ring must be aligned accordingly
[10-1].
• Press the air distribution ring in evenly.
• Perform the steps to fit the new nozzle set (see chapter 10.1).
10.3. Replacing the paint needle seal retainers
If the two paint needle seal retainers are damaged, material can leak
from the gun body inspection hole [1-14].
→ Replace the paint needle seal retainer immediately.
Dismantle the paint needle seal retainer
■ Unscrew the regulating cap [11-1].
■ Unscrew the end cap [11-2].
■ Remove both springs [11-3], [11-4].
■ Remove paint needle [11-5].
134
Attention!
using the SATA extraction tool
[9-1]