Deactivating Earth Monitoring; Activating Earth Monitoring; Pausing Charging; Stopping Charging - Porsche Mobile Charger Connect Manual De Instrucciones

4. After a few minutes, the display switches to
standby mode.
The vehicle is charged.
Information
– Charging is controlled by the vehicle. Charging
can only be stopped on the vehicle.
– The charge status is shown on the display
provided the charger is not in standby mode. The
display can be switched on again by pressing the
Power button .
– A high-temperature switch-off function prevents
overheating during charging.

Pausing charging

Charging is controlled by the vehicle and may
occasionally be paused, e.g. in order to optimise
power consumption.
A pause in charging is indicated on the control unit:
Power button lights up white.
Status LEDs flash blue.
The display switches on.
The vehicle starts charging again automatically.
Charging can be stopped on the vehicle.

Stopping charging

b The charging process has finished successfully.
Power button lights up white.
Status LEDs light up green.
The display switches on and shows information
about the completed charging process. After a
few minutes, the charger switches to standby
mode.
e Disconnect the vehicle plug from the vehicle
charge port.

Charging Current Limiting

The control unit detects the voltage and the available
current automatically.
The charging power to be used for charging can be
set using charging current limiting. The last charging
current set is saved.
On delivery, the charging current is automatically
limited to 50 % to prevent overheating of the
electrical installation.
If the charger is connected to an energy manager,
the charging current is limited in line with the values
preset in the energy manager.
The maximum available charging current can also be
reduced by other consumers in the home network,
e.g. by an electric heater or water heater.
The charging power must never be set higher than
the maximum available power of the electrical circuit
used. If you are unsure about this, contact a qualified
electrician.
Ground monitoring
Electric shock, short
DANGER
circuit, fire, explosion
Use of the charger without active ground monitoring
can cause electric shocks, short circuits, fire,
explosions or burns.
e The charger should preferably be operated in
earthed mains supply systems.
e Only deactivate ground monitoring in non-
earthed mains supply systems.
e Only activate ground monitoring in earthed mains
supply systems.
f Refer to chapter "Activating ground
monitoring" on page 33.
Charging Current Limiting
Deactivating ground monitoring
b An error message indicating an interrupted or
absent protective conductor is shown on the
display.
b Ground monitoring has interrupted the charging
process or prevents it from starting.
Power button lights up red.
Status LEDs light up red.
An error message appears on the display.
1. To deactivate ground monitoring, acknowledge
the error message with C .
ONFIRM
2. Press the Power button and keep it pressed for
3 seconds.
3. Acknowledge the deactivation of ground
monitoring with C .
ONFIRM
Monitoring remains deactivated for subsequent
charging processes.

Activating ground monitoring

If the charger is operated in an earthed mains supply
system, activate ground monitoring.
1. Call up the G menu
ROUND MONITORING
(S > G
ETTINGS ROUND MONITORING
2. Select A to activate ground monitoring.
CTIVATE
When ground monitoring is activated, the menu
item G will not appear in the
ROUND MONITORING
S menu.
ETTINGS
DE
EN
FR
IT
ES
PT
NL
SV
FI
DA
NO
EL
CZ
HU
PL
). HR
SR
SK
SL
ET
LT
LV
RO
BG
MK
33