General Set Up Screen - Briggs & Stratton G80 Manual Del Operador

General Set Up Screen

For general set up, press and hold the left arrow and right arrow
outlined below.
NOTE: Date and Time were set at the factory and stored in the control panel memory. The Exercise Cycle was
also set at the factory. The default exercise cycle occurs on Tuesdays, at 2:00 P.M. Central Standard Time. To
update or change these settings, follow the steps below.
SET DATE
or
SET TIME
or
SET EXERCISE
CYCLE
EVENT LOG
IF DURING PROGRAMMING NO BUTTONS ARE PRESSED FOR 30 SECONDS,
THE CONTROL PANEL WILL AUTOMATICALLY EXIT THE PROGRAM MODE.
YEAR
FLASHING
or
HOURS
FLASHING
or
OFF
or
DAY OF
WEEK
FLASHING
or
Display will scroll last service code event, date, time,
and ambient temperature of when the event occurred.
for 3 seconds. Follow the prompts as
MONTH
FLASHING
or
MINUTES
FLASHING
or
If set to OFF, display will read:
EXERCISE CYCLE OFF
HOURS MINUTES
FLASHING FLASHING
or or
DAY##
FLASHING
or
AM/PM
FLASHING
or
AM/PM
FLASHING
or
or
or
17