Setting Exercise Timer - Briggs & Stratton G80 Manual Del Operador

Setting Exercise Timer

The generating set is equipped with an exercise
timer. During the exercise period, the unit runs for
approximately 20 minutes and then shuts down.
Electrical load transfer DOES NOT occur during the
exercise cycle (unless an utility power outage occurs).
The generating set will only enter the exercise cycle if
the unit is in the AUTO mode and this exact procedure
is followed.
To set the exercise timer:
NOTICE The generating set is preset with an exercise
cycle of Tuesday at 2:00 PM, Central Time. To change
the cycle setting, proceed to the following steps:
1. Choose the day and time you want your
generating set to exercise.
2. Press and hold the left arrow and right arrow
simultaneously for 3 seconds to enter the General
Set-Up program mode. See General Set-Up flow
chart in Menu Section.
3. Verify and/or set the time and date on the unit.
4. Go to the SET EXERCISE prompt and hit the "OK"
button.
20
NOTICE Items will flash until they are selected.
SELECT DAY: Use the left or right arrow to toggle
through the days of the week, Once the day is
selected, hit the "OK" button.
SELECT HOUR: Use the left or right arrow
to toggle through between 1 and 12. Choose
the hour of day you want the generating set to
exercise then hit the "OK" button.
SELECT MINUTE: Use the left of right arrow to
toggle between :00 and :59. Choose the minute
of the day you want the generating set to exercise
then hit the "OK" button.
SELECT AM/PM: Use the left of right arrow to
toggle between AM and PM. Once chosen, hit the
"OK" button.
NOTICE During the weekly exercise cycle, the
generating set will run for 20 minutes, but it will not
supply power to the home.
If you want to change the day and time the unit
exercises, simply perform the procedure again.
To turn off the generating set exercise cycle, go to
the OFF selection within the day of the week menu
and press OK. The display will then scroll: EXERCISE
CYCLE OFF.