Initial Operation; Working Advice; Maintenance And Service; Maintenance And Cleaning - Bosch GLI VariLED Professional Manual Original

OBJ_DOKU-31566-005.fm Page 16 Monday, May 4, 2015 5:13 PM
16 | English
To remove the battery 4, press the battery unlocking button 5 and pull the battery to-
ward the rear out of the cordless worklight. Do not exert any force when doing this.
Observe the notes for disposal.
Operation

Initial Operation

Inserting the battery
Insert the charged battery 4 into lamp head 3 until it can be felt to engage and faces
flush against the lamp head 3.
Switching On and Off
To start the cordless worklight, press the On/Off switch 2.
To switch off the cordless worklight, press the On/Off switch 2 again.
To save energy, only switch the cordless worklight on when using it.
Temperature Dependent Overload Protection
When exceeding the allowable heat-sink temperature of 60 °C, the cordless worklight
flashes 3x and then switches off. Allow the cordless worklight to cool down, then
switch the cordless worklight on again.

Working Advice

When the lighting duration is ≤10 minutes, the luminous efficiency of the cordless
worklight is lower.
The lens plate 1 is used to scatter or diffuse the light when using the cordless work-
light e. g., as a reading lamp.
Swivelling the Lamp Head (see figure A)
You can swivel the lamp head 3 maximum 135° in 27° steps.
Carrying Handle (see figure B)
The cordless worklight can be carried or fastened to an object with the carrying han-
dle 7.

Maintenance and Service

Maintenance and Cleaning

When the battery is no longer operative, please refer to an authorised after-sales ser-
vice agent for Bosch power tools.
1 609 92A 19Z | (4.5.15) Bosch Power Tools