Powering Up The Multimeter; Powering Down The Multimeter; The Prop - Chauvin Arnoux C.A 5231 Manual De Instrucciones

English

2.2 POWERING UP THE MULTIMETER

The switch is set to
choice. All segments of the display unit light for a few seconds
(see Figure 2, § 1.1) the screen corresponding to the chosen
function then appears. The multimeter is now ready for
measurements.

2.3 POWERING DOWN THE MULTIMETER

The multimeter can be switched off manually, by setting the
switch to
unused for 15 minutes. At the 14th minute, 5 beeps warn that
the multimeter is about to be switched off. To reactivate the
instrument, press any key on the keypad.
Note: the
multimeter; it remains active for contact-free detection of the
presence of the network voltage (NCV).

2.4 THE PROP

The prop can be placed in either of two positions according to
how it is to be used: to suspend the multimeter from a hook
(position 1) or to stand it in an inclined position on a support
(position 2). To change the position of the prop, proceed as
follows:
Positon 1 : raise the stand
Hooking
zone for
multi-position
attachment
accessory
35 - 117
. Turn the switch to the function of your
, it will also switch itself off automatically if left
position does not completely switch off the
Position 2 : lower the stand