Publicidad
Step 8
Separate the EXTENSION SLIDES (KK) from the EXTENSION
å
RAILS (JJ) as shown in the upper diagram below. Be prepared, the
parts are greasy.
Fasten the EXTENSION RAILS (JJ) to the LEFT END (B) and LEFT
å
UPRIGHT (C). Use four GOLD 5/16" FLAT HEAD SCREWS (FFF).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole
å
shown in the enlarged diagram. Then, slide the inner cartridge of
the EXTENSION RAIL out to fi nd the other hole that lines up with
the hole in the END. Turn a SCREW into this hole.
Finished edge
Open end
Page 12
KK
Push the black lever in and pull the SLIDE from the RAIL.
Finished edge
JJ
B
L
412320
JJ
JJ
C
FFF
GOLD 5/16" FLAT HEAD SCREW
(4 used in this step)
www.sauder.com/services
Open end
M
Publicidad
