Sauder 412320 Manual Del Usuario página 9

Step 5
Carefully turn the ENDS (A and B) over.
å
Turn twelve BLACK 9/16" FLAT HEAD SCREWS (EEE) into the
å
ENDS (A and B) until the shoulders of the SCREWS rest on the
surfaces of the ENDS.
First, slide the LOWER MOLDINGS (EE and GG) onto the ENDS (A and B).
å
Line up the grooves in the MOLDINGS over the heads of the SCREWS in
the ENDS.
Second, slide the END MOLDINGS (DD and II) onto the ENDS (A and B)
å
until they are against the LOWER MOLDINGS. Line up the grooves in the
MOLDINGS over the heads of the SCREWS in the ENDS.
2nd
Shoulder
2nd
These edges should be even.
www.sauder.com/services
Apply pressure with your hands as you guide the
MOLDINGS over the SCREWS and onto the ENDS.
II
DD
B
1st
EE
A
Shoulder
412320
Remember:
Righty tighty.
Lefty loosey.
BLACK 9/16" FLAT HEAD SCREW
(12 used in this step)
These edges should be even.
GG
1st
EEE
Page 9