Sauder 412320 Manual Del Usuario página 26

Step 22
1
D14
R
Groove
Insert the DRAWER SIDES (D14 and D15) at an angle
å
into the slot at each end of the DRAWER FRONT (R).
3
Fasten the DRAWER BACK (D78) to the DRAWER SIDES (D14
å
and D15). Use four BLACK 1-9/16" FLAT HEAD SCREWS (30S).
NOTE: Be sure the DRAWER BOTTOM (D716) inserts into the
å
groove of the DRAWER BACK (D78).
Page 26
The tabs should insert freely
into the slots. Gently tilt the
DRAWER SIDES side to side
until the tabs slip into the slots.
D15
D78
D14
D716
VIEW THE T-LOCK BOX VIDEO
2
U n
s u
D14
Be sure the DRAWER
BOTTOM inserts into the
DRAWER FRONT groove.
Slide the DRAWER BOTTOM (D716) into the grooves in the
å
DRAWER SIDES (D14 and D15) and DRAWER FRONT (R).
Start each screw a few turns before
completely tightening any of them.
BLACK 1-9/16" FLAT HEAD SCREW
D15
412320
With the palm of your
hand, tap the DRAWER
BOTTOM down into
the groove.
fi n
i s h
r f a
e d
c e
D716
D15
R
30S
(4 used in this step)
www.sauder.com/services