Shure ULX-D Serie Manual De Instrucciones página 12

Receiver Home Screen
The home screen displays the following information for each receiver
channel:
1 G:01 CH:01 TxOn
2 G:01 CH:02 TxOn
3 G:01 CH:03 TxOn
4 G:01 CH:04 TxOn
• Group and Channel
• Transmitter Status: or
NoTx TxOn
Press the button to access a channel menu screen.
SEL
Transmitters
ULXD1
① Power LED
• Green = unit is powered on
• Red = low battery or battery error (see Troubleshooting)
• Amber = power switch is disabled
② On/Off Switch
Powers the unit on or off.
③ SMA Connector
Connection point for RF antenna.
12
, battery icon/remaining battery life
ULXD2
on
Receiver Output Level
The following table describes the typical total system gain from the audio
input to the receiver outputs:
Output Jack System Gain (gain control = 0dB)
XLR (line setting) +24 dB
XLR (mic setting) -6 dB*
*This setting matches a typical wired SM58 audio signal level.
④ LCD Display:
View menu screens and settings. Press any control button to activate the
backlight.
⑤ Infrared (IR) Port
Align with the receiver IR port during an IR Sync for automated transmitter
programming.
⑥ Menu Navigation Buttons
Use to navigate through parameter menus and change values.
Acts as a 'back' button to return to previous menus or pa-
exit
rameters without confirming a value change
Enters menu screens and confirms parameter changes
enter
Use to scroll through menu screens and to change param-
▼▲
eter values
⑦ Battery Compartment
Requires Shure SB900 rechargeable battery or 2 AA batteries.
⑧ AA Battery Adapter
• Handheld: rotate and store in the battery compartment to use a Shure
SB900 battery
• Bodypack: remove to accommodate a Shure SB900 battery
⑨ Bodypack Antenna
For RF signal transmission.
⑩ Integrated Antenna
For RF signal transmission.
⑪ Microphone Cartridge
See Optional Accessories for a list of compatible cartridges.
⑫ TA4M Input Jack
Connects to a 4-Pin Mini Connector (TA4F) microphone or instrument
cable.