Operation Tips; Operate As A Mulcher; Operate As A Blower; Maintenance - GreenWorks BVA802 Manual Del Operario

4.3

OPERATION TIPS

• Blow around the outer edge of the unwanted materials to
prevent the unwanted materials from scattering.
• Use rakes and brooms to clear the unwanted material
before you blow.
• Make the surfaces wet before you clear the unwanted
material in dusty conditions.
• Look out for children, pets, open windows, and cleaned
cars during operation.
•

Clean the machine.

• Discard the unwanted material when you complete work.
4.4

OPERATE AS A MULCHER

Figure 10.
1. Hold the machine tightly.
2. Tilt the mulcher tubes (2 - 4 in. or 5 - 10 cm).
3. Use a sweeping action to collect light unwanted
materials.
NOTE
Make sure that you install and zip the bag.
NOTE
Use the shoulder strap.
4.5

OPERATE AS A BLOWER

Figure 11.
1. Hold the machine tightly.
2. Operate from side to side.
3. Move the machine forward slowly.
4. Keep the collected unwanted materials in front of you.
Use rakes and brooms to loosen the unwanted material
before you blow.
Use the low speed to move dry items, and high speed to
move heavy items such as large unwanted materials or
gravel.
5

MAINTENANCE

CAUTION
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
NOTE
NOTE
English
Do not use strong solvents or detergents on the plastic
housing or components.
Disconnect the plug from the power source before
maintenance.
5.1 CLEAN THE MACHINE
The machine must be dry. Humidity can cause risks of
electrical shocks.
• Clear the unwanted material out of the air vent with a
vacuum cleaner.
• Do not spray the air vent or put the air vent in solvents.
• Clean the housing and the plastic components with a
moist and soft cloth.
5.2

CLEAN THE COLLECTION BAG

• Wear safety glasses and a dust mask.
• If it is necessary, clean the bag 1 time a year or more.
1. Remove the bag.
2. Turn the bag inside out.
3. Hang the bag up and clean it.
4. Hang the bag to dry.
5. Turn the bag right-side out and install it again.
5.3 CLEAN A BLOCKED TUBE /
IMPELLER
1. Wait until the machine fully stops.
2. Remove the blower tube or mulcher tubes and the bag.
3. Remove the material that causes a blockage of the tube or
impeller.
4. Make sure that the impeller has no damage.
5. Turn the impeller with the hand to make sure that there is
no blockage.
6. Install the blower tube or mulcher tubes and the bag.
Avoid the intake of large objects that could damage the
impeller.
5.4

ADJUST THE SHOULDER STRAP

1. Pull the tab to increase the length of the shoulder strap.
2. Pull the strap to decrease the length of the shoulder strap.
5
CAUTION
WARNING
CAUTION
WARNING
EN