Technical Data - Würth WTS 1800 Traducción Del Manual De Instrucciones De Servicio Original

Technical data

Truck Start 12/24V
Art.
Internal battery type
Output voltage
Rated capacity
Amperage upon start
Maximum amperage
Direct current output
(Max. continual load)
Product weight
Charger
Intended use
The device is for starting vehicles with 12 V or 24 V
when the start-up capacity of the vehicle batteries is
insufficient.
Any other use is considered improper.
The user is responsible for damage result-
ing from improper use.
Device elements
Overview [fig. I]
1 16 A fuse switch
2 12 V output backed up
3 Alarm buzzer
4 Voltmeter
5 Voltmeter pushbutton switch
6 12 V and 24 V connections
7 Connection for charger
8 Voltage connector
0772 990
12 V AGM lead-acid
12 V DC/6 cells
24 V DC/12 cells
2 x 32 Ah
2400 CA (12 V)
6200 PA (12 V)
12 V DC/16 A
31 kg
Input: 220 - 240 V AC
– 50/60 Hz
Output: 12 V DC – 4 A
Start-up
Voltmeter
▸
Press the knob, to check the charging level of the
device
Half an hour after removal of the charger, the
3
voltmeter must indicate approx. 13 volts for a full
charge.
AC generator (alternator)
▸
To test the functionality, leave the device con-
nected to the battery after starting the engine at
2000 rpm.
▸
Press the pushbutton.
The voltmeter must indicate 14 to 14.4 V.
3
Charging the booster
Note
Never leave the booster in discharged
state.
▸
Connect the supplied charger to the AC 230 V
mains.
▸
Then connect the charger with the booster to the
connection [7].
Operation (fig. II)
Attention!
▸
Do not use the device while it is connected to
the charger!
▸
Always charge the device completely prior to
use, since the internal battery can otherwise be
damaged.
▸
Switch off the vehicle ignition.
Note
The voltage connector must not be
plugged in.
13