Dremel 4300 Instrucciones De Funcionamiento página 15

1600A00N3H.qxp_4300 7/8/16 10:33 AM Page 15
work in one pass. To make a cut, for example,
pass the tool back and forth over the work,
much as you would a small paint brush. Cut a
little material on each pass until you reach the
desired depth. For most work, the gentle
touch is best. With it, you have the best
control, are less likely to make errors, and will
get the most effi cient work out of the
accessory.
FIG. 7
Questions or Problems? Call 1-800-437-3635
or check our website at www.Dremel.com
TOOL HANGER
The hanger is provided for the use of hanging
your tool while using the Flex Shaft or for
storage. If you do not use the hanger, snap it
back into place so it will be out of the way while
the tool is in use (Fig. 1).
FIG. 8
15