Dremel 4300 Instrucciones De Funcionamiento página 30

1600A00N3H.qxp_4300 7/8/16 10:34 AM Page 30
Note: Each number settings listed in the speed charts = x 1,000 RPMs
* Speed for light cuts, Caution - burning on deep grooves.
• Depending on cutting direction relative to grain.
Catalog
Number
502, 503, 504, 505
Catalog
Number
511E, 512E
Catalog
Number
EZ471SA,
EZ472SA,
EZ473SA
Catalog
Number
150
Catalog
Number
662DR, 663DR
Catalog
Number
569, 570
30
Speed Settings (Continued)
Flapwheels
Soft Hard Laminates
Wood Wood /Plastics
25-35 18-24 5-8
Finishing Abrasive Buffs
Soft Hard Laminates
Wood Wood /Plastics
12-17 12-17 9-11
Detail Abrasive Brushes
Soft Hard Laminates
Wood Wood /Plastics
5-17 5-17 5-17
Drill Bit
Soft Hard Laminates
Wood Wood /Plastics
25-35 18-35 5-11
Glass Drilling Bits
Soft Hard Laminates
Wood Wood /Plastics
- - -
Grout Removal Bits
Soft Hard Laminates
Wood Wood /Plastics
For use on wall and floor grout
Aluminum, Shell/
Steel
Brass, etc. Stone
25-35 18-35
Aluminum, Shell/
Steel Stone Ceramic Glass
Brass, etc.
12-17 12-17
Aluminum, Shell/
Steel
Brass, etc. Stone
5-17 5-17
Aluminum, Shell/
Steel
Brass, etc. Stone
- 12-17
Aluminum, Shell/
Steel Stone Ceramic Glass
Brass, etc.
- - 5-17
Steel Aluminum, Shell/
Brass, etc. Stone
Ceramic Glass
- - -
- - -
Ceramic Glass
- - -
Ceramic Glass
- - -
5-17 5-17
Ceramic Glass
- 12-24 -