1600A00N3H.qxp_4300 7/8/16 10:34 AM Page 36
Shield Rotary Tool Attachment Model A550
accessory. Wear eye and respiratory
protection. Replace Dremel Shield Rotary Tool
Attachment if spinning accessory is no longer
visible through the Shield during use.
The Dremel Shield is not recommended for
use carving, routing, and drilling accessories.
Please refer to the Dremel Rotary Tool's
Owner's Manual for usage and installation of
any Dremel Accessories.
Dremel Shield Rotary Tool Attachment
Installation Instructions:
1. Remove the nose cap A from the end of the
tool and set nose cap aside. The original
nose cap must be reinstalled when this
attachment is not used (Fig. D1).
2. Screw the Shield onto the tool using the
lock nut B (Fig. D2).
FIG. D2
36
Read the manual for the
use of the tool with this
FIG. D1
A
B
3. Position the Shield such that it will redirect
debris, sparks, and dust away from the user
using the positioning tabs C (Fig. D3).
Using the Dremel Shield Rotary Tool
Attachment:
Always turn tool power off before adjusting
position, changing accessory, and removing
attachment. Dremel Rotary Tools cut, sand,
grind, and polish in many directions. To
accommodate the Dremel Rotary Tools'
maneuverability, the Dremel Shield can be
quickly positioned and repositioned with a turn
to the right or left. To extend the life of the
Dremel Shield periodically clean with a soft
bristle brush or compressed air.
FIG. D3
C
C