Vision Fitness TF40 Manual Del Propietário página 11

TF20 ASSEMBLY STEP 4
HARDWARE FOR STEP 4 :
TF20
ARC
SPRING
BOLT (A)
WASHER (E)
WASHER (B)
ONLY
8.4 mm 20 mm
8.2 mm
Qty: 6
Qty: 6
Qty: 6
TF20 ONLY
CONSOLE BASE
CONSOLE CABLES
CONSOLE MAST
BASE FRAME COVER
SCREWS (M)
BASE FRAME
20
VF_12_Treadmills_OM_Trilingual_Rev2_0.indd 20-21
NOTE: This step is for TF20 models only.
Open HARDWARE FOR STEP 4.
A
SCREW (M)
20 mm Gently place CONSOLE BASE on top of
B
Qty: 4
CONSOLE MASTS.
NOTE: Be careful not to pinch the console
BOLTS (A) cables while attaching the console base.
SPRING WASHERS (B)
ARC WASHERS (D)
Connect the CONSOLE CABLES and tuck
C
them inside the CONSOLE MASTS and slide
CONSOLE BASE into CONSOLE MASTS.
Connect the CONSOLE BASE to CONSOLE
D
MASTS using 6 ARC WASHERS (E), 6
SPRING WASHERS (B) and 6 BOLTS (A).
NOTE: Tighten all bolts from STEPS 1–3.
Attach BASE FRAME COVERS to BASE
E
FRAME using 4 SCREWS (M).
ASSEMBLY STEP 5
HARDWARE FOR STEP 5 :
FLAT
SPRING
BOLT (I)
WASHER (H)
WASHER (J)
45 mm
8 mm
8 mm
Qty: 2
Qty: 4
Qty: 2
BOLT (I) BOLT (I)
FLAT WASHERS (H) FLAT WASHERS (H)
CONSOLE CONSOLE
CONSOLE REAR COVER CONSOLE REAR COVER
CONSOLE BASE CONSOLE BASE
PRE-INSTALLED PRE-INSTALLED
SCREWS SCREWS
CONSOLE CABLES CONSOLE CABLES
FLAT WASHERS (H) FLAT WASHERS (H)
SPRING WASHER (J) SPRING WASHER (J)
NUT (K) NUT (K)
T40 ONLY:
SUPPORT BAR SUPPORT BAR
SUPPORT BAR CAP SUPPORT BAR CAP
Open HARDWARE FOR STEP 5.
A
Remove 2 PRE-INSTALLED SCREWS to
B
NUT (K)
remove CONSOLE REAR COVER from the
Qty: 2
CONSOLE.
Attach the CONSOLE to the CONSOLE BASE
C
using 2 BOLTS (I) and 2 FLAT WASHERS
(H) from above and 2 FLAT WASHERS (H) 2
SPRING WASHERS (J) and 2 NUTS (K) from
below.
NOTE: Be careful not to pinch the console
cables while attaching the console.
Connect the CONSOLE CABLES to the
D
CONSOLE.
Re-attach the CONSOLE REAR COVER to
E
the CONSOLE using 2 PRE-INSTALLED
SCREWS.
T40 ONLY: Insert SUPPORT BAR CAPS into
F
bottom of SUPPORT BARS.
ALL
MODELS
21
8/18/14 11:33 AM