Vision Fitness TF40 Manual Del Propietário página 8

ASSEMBLY STEP 2
HARDWARE FOR STEP 2 :
ALL
SPRING ARC
BOLT (A)
MODELS WASHER (B) WASHER (C)
20 mm
8.2 mm 8.4 mm
Qty: 6
Qty: 6 Qty: 4
T40 SHOWN
CONSOLE CABLES
RIGHT CONSOLE MAST
BOLT (A)
SPRING WASHER (B)
FLAT WASHER (D)
ARC WASHERS (C)
14
VF_12_Treadmills_OM_Trilingual_Rev2_0.indd 14-15
Open HARDWARE FOR STEP 2.
A
B Guide CONSOLE CABLES from HANDLEBARS
FLAT
through and out of the tops of the CONSOLE
WASHER (D)
8.2 mm
MASTS.
Qty: 2
C Slide HANDLEBARS onto CONSOLE MASTS.
NOTE: Do not pinch console cables while
attaching the handlebars.
RIGHT HANDLEBAR
D Attach right HANDLEBAR to right CONSOLE
MAST using 1 FLAT WASHER (D), 1 SPRING
WASHER (B) and 1 BOLT (A) from the inside and
2 ARC WASHERS (C), 2 SPRING WASHERS (B)
and 2 BOLTS (A) from below.
NOTE: Do not tighten bolts until step 4 is complete.
Repeat on other side.
E
T40 ASSEMBLY STEP 3
T40 HARDWARE FOR STEP 3 :
ARC
SPRING
WASHER (E)
WASHER (B)
8.4 mm
8.2 mm
Qty: 4
Qty: 4
BOLT (A)
20 mm
Qty: 2
T40 ONLY
ARC WASHER (E)
SPRING WASHER (B)
HANDLEBAR BOLT (A)
SUPPORT BAR BOLT (F)
BASE FRAME
SPRING WASHER (B)
ARC WASHER (E)
NOTE: This step is for T40 models only.
Open HARDWARE FOR STEP 3.
A
BOLT (F)
95 mm
Qty: 2
Attach the right SUPPORT BAR to the BASE
B
FRAME using 1 ARC WASHER (E), 1 SPRING
WASHER (B) and 1 BOLT (F).
NOTE: Do not tighten bolts until step 4 is complete.
Attach the right SUPPORT BAR to the
C
HANDLEBAR using 1 ARC WASHER (E), 1
SPRING WASHER (B) and 1 BOLT (A).
D Repeat on other side.
T40
ONLY
15
8/18/14 11:33 AM