Mowox PM 4645 SEHW Instrucciones De Funcionamiento Originales página 50

NOTE: - When storing any type of power equipment in an unventilated or material storage shed,
-Care should be taken to rust-proof the equipment. Using a light oil or silicone, coat the equipment, especially
cables and all moving parts.
- Be careful not to bend or kink cables.
- If the starter rope becomes disconnected from rope guide on handle, disconnect and ground the spark plug
wire, Depress the blade control handle and pull the starter rope out from engine slowly. Slip the starter rope
into the rope guide bolt on handle.
Transport
Turn the engine off and allow the engine to cool down. Then disconnect the spark plug wire and empty the fuel
tank according to the instructions in the engine manual. Ensure not to bend or damage the cutter when pushing
the lawnmower over obstacles.
13. TROUBLESHOOTING
PROBLEM PROBABLE CAUSE
Engine does not Throttle choke not in the
start. correct
prevailing conditions.
Fuel tank is empty.
Air cleaner element is dirty.
Spark plug loose.
Spark plug wire loose or
disconnected from plug.
Spark plug gap is incorrect.
Spark plug is defective
Carburetor is flooded with
fuel
Faulty ignition module
Engine difficult Dirt, water, or stale fuel tank. Drain fuel and clean tank. Fill tank with clean, fresh fuel
to start or loses
Vent hole in fuel tank cap is
power.
plugged.
Air cleaner element is dirty.
Engine Spark plug is defective.
operates
erratically.
Spark plug gap is incorrect.
Air cleaner element is dirty.
Engine idles Air cleaner element is dirty.
poorly.
Air slots in engine shroud are
blocked.
Cooling
passages
CORRECTIVE ACTION
Move throttle choke to correct position
position for the
Fill tank with fuel: refer to ENGINE OWNERS MANUAL.
Clean air cleaner element: refer to ENGINE OWNERS
MANUAL
Tighten spark plug：refer to ENGINE OWNERS MANUAL
Install spark plug wire on spark plug.
Set gap between electrodes: refer to ENGINE OWNERS
MANUAL
Install new, correctly gapped plug: refer to ENGINE
OWNERS MANUAL
Remove air cleaner element and pull starter rope
continuously until carburetor clears itself and install air
cleaner element.
Contact the service agent.
Clean or replace fuel tank cap.
Clean air cleaner element.
Install new, correctly gapped plug: refer to ENGINE
OWNERS MANUAL
Set gap between electrodes: refer to ENGINE OWNERS
MANUAL
Clean air cleaner element: refer to ENGINE OWNERS
MANUAL
Clean air cleaner element: refer to ENGINE OWNERS
MANUAL
Remove debris from slots.
fins and air Remove debris from cooling fins and air passages.
under engine
23