General Information - JANE nurse DRIVER 2 Instrucciones

GB

GENERAL INFORMATION

1 FITTING THE BELT SYSTEM
CORRECT SHOULDER STRAP HEIGHT
Check that the shoulder straps are at the correct height for the child. The shoulder straps should always
be inserted through the slots in the cover and the shell of the seat that are closest to the top of the child's
shoulders.
2
ADJUSTING THE HEIGHT OF THE SHOULDER STRAPS
Step 2.1. Press the harness adjuster lever and pull both harness straps forward to loosen them.
Step 2.2. Turn the seat around, and from the back of the seat take the straps out of the metal junction plate.
Step 2.3. Pull the ends of the straps through the slots on the front of the seat and reinsert them through the
required slots.
Step 2.4. Check that the harness straps are inserted through the same slots on both sides of the seat and make
sure the straps are not twisted.
3 FASTENING THE SAFETY SEAT BUCKLE
Step 3.1. Slot the two metal sections of the buckle connectors together.
Step 3.2. Slot the two buckle connectors into the slot on the top of the buckle until they click into place.
Step 3.3. Check that the harness is correctly locked by pulling the shoulder straps upwards.
To release the harness, press the red button on the buckle downwards.
4
TIGHTENING AND SLACKENING THE HARNESS
TIGHTENING THE HARNESS
Adjust the harness system comfortable every time you place the child in the restraint system.
Step 4.1. Place the child in the child restraint system.
Step 4.2. Adjust the shoulder straps and the headrest height.
Step 4.3 Check that the straps are not twisted, bring the two metal parts together and slot them into the buckle.
Step 4.4 Tighten the harness straps as much as possible without causing the child any discomfort.
*To release the child, follow the instructions above in reverse order.
5
ADJUSTING THE HEADREST HEIGHT
9 headrest height positions
As children are not all the same height, the headrest may be adjusted upwards or downwards. A correctly
adjusted headrest ensures optimal protection for the child in the safety seat. Pull the adjusting ring of the
headrest upwards, move the headrest up or down, and release the adjuster to fasten the headrest in the
required position. Important: After each adjustment, check that it is properly engaged by sliding the headrest
downwards slightly.
6
USING FOR GROUP 0+ (0-13 KG)
The safety seat should be installed in the rear facing position. The safety seat must only be used in the fully
reclined position. Check the blue mark on the base of the safety seat for reference.
Step 6.1. Place the safety seat firmly against the back of the forward-facing vehicle seat, as shown in the
diagram.
Step 6.2. Pull the lap and diagonal section of the vehicle seat belt until fully extended and place the lap part
of the belt through the hook on the base (from top to bottom) on one side and through the hook (from top to
bottom) on the other side and then fasten the vehicle seat belt. Check that the lap belt goes under the base.
At the same time, place the diagonal belt in the headrest guide.
Step 6.3. Tighten the vehicle seat belt by pulling first the lap section of the belt and then the diagonal part in
the direction shown in the diagram. Check that the vehicle seat belt is not twisted.
Step 6.4. Place the child in the safety seat and make sure that the shoulder straps are at the right height.
Check that the safety seat is correctly installed every time you drive with the child in the car. Gently twist and
pull the restraint system from side to side to make sure that the vehicle seat belt has not come loose and that
the safety seat does not move about.
To remove the safety seat follow the instructions above in reverse order.
14
Note: The maximum reclining position is suitable only for group 0+.