Graco mosaic Instrucciones página 8

GB
INSTRUCTIONS
Rear wheels
Pull axle through axle hole as shown.
1
Attach retainer to axle as shown.
2
Attach cap over retainer as shown.
3
Remove pin and washer from axle.
4
Attach wheel to axle.
5
Reattach washer and then pin.
6
Attach hubcap.
7
Repeat Steps 1 through 7 for other wheel.
1
To open stroller
See images
8
Armbar
- Push arm bar into hole on side of
11 13
pushchair. Click into place.
14
To open, press button.
Front wheels
Pull FIRMLY on wheel assembly to be
15
sure it is securely attached.
Brakes
Check to make sure brake is on by
19
trying to push the pushchair.
Hood
See images
16 17
To secure your child
See images
20
To adjust
Use either shoulder harness anchor in
22
the slots that are closest to child's
shoulder height.
Use slide adjuster for further
24
adjustment.
7
, 1 and
9 10
, and
18
-
24
To recline back
To recline, pull recline tab down.
25
To raise, pull recline strap up.
26
Swivel wheels
/ Front swivel wheels lock for use on
27 28
uneven surfaces such as grass, stones
or gravel.
To remove armbar
/ To remove, press metal button on
29 30
underside of armbar.
Adjustable legrest
See images
To fold stroller
See images
Before folding, fold hood,
brakes, and remove apron and car seat
if installed.
Travel system
Recline the stroller seat back to its
37
lowest position. Snap carrier into
position ontoarm bar.
Pull straps through vehicle belt hooks
38
on both sides of the car seat. Check
that infant carrier is securely attached
by pulling up on it.
To remove carrier:release strapsfrom
39
carrier, squeeze release handle at back
of carrier, and lift carrier out of the
stroller.
Rain Cover
40
Apron
41
9

-
31 32
-
36
33
apply
34