Angle-Adjustable Footplates; Horizontally-Adjustable Legrests (Optional) - B+B BX 11 Manual De Instrucciones

at 20 mm steps.
• To do this remove both socket screws on the legrest tube (inner and
outer) and adjust to the required length (Fig. 16).
• Re-tighten the screws.

Angle-adjustable footplates

The angle of the footplates can be adjusted (Fig. 17).
• Unscrew the socket screw.
• Twist the sprocket to adjust the footplate to the required position.
• Re-tighten the screw.
4.2.3. Horizontally-adjustable
rests (optional)
Assemble, disassemble and swing them away as for the standard leg-
rests.
Carry out the same adjustments on both sides.
To adjust, undo the clamp lever, then adjust the legrest to the required
length and then tighten the clamp lever
The horizontal adjustment works as follows:
• Push the locking lever forwards.
• by lifting or lowering the footplate receiver tube you can get the
legrest into the required position.
• Release locking lever; legrest locks into place automatically.
Never stand on the footplate and when swinging
it away, watch your fingers as there is a risk of
pinching
To change seat, the legrest must be swung away
or removed. Never sit on the legrest. Risk of tipping
over!
Bischoff & Bischoff GmbH |2021-09-28 - Revision: 1
Adaptive wheelchair |
BX 11 | BX 11 S
16
2
leg-
1
17
2
61