Safety Systems; Cleaning - Zummo Z06 Manual Del Usuario

The display is limited to five digits, making it so a maximum of 99,999 operations can be
displayed. But if you want to know the number of times that the counter has turned over, turn
off the machine using the power switch and turn it back on again while holding down the
STOP button. The number that appears is the number of times the counter has turned over.
*(operation = complete set of steps in squeezing a piece of fruit.)
7

SAFETY SYSTEMS

The machine is equipped with several safety systems:
1
If the cover is not properly in place, with its clasps fully fitted inside the slots (Figs. 8
& 9), the display will show the StoP message and the buttons will not respond.
2 If the tray holding the squeezer and the blade are not properly in place, and the
nuts not tightened, the machine will not run and StoP will appear on the display
(Fig. 10)
3 If for some reason the machine were to become blocked while running, the motor
will automatically be stopped after a few seconds, and a blinking A will appear on
the display, waiting for the cause of the blockage to be removed.
4
The machine is equipped with a system of thermal protection in the motor. In the
event of overheating, the machine will stop and the display will show the StoP
message. In such a case, wait roughly five minutes for the temperature to go down,
at which point StoP will be replaced on the display by the last selection. Check to
make sure the ventilation grating is unobstructed.
5
If no message appears on the display, this will be due to the lack of voltage. Check
that the power switch is turned on and that the safety fuse to the power jack has not
burnt out. Observe that there are two fuses (Fig.11): the first fuse is the one that
may be burnt out while the second one is the spare fuse.
8

CLEANING

We recommend that the squeezing area be cleaned on a daily basis.
It is recommended to halt the machine by pressing StoP before cleaning (never stop using the
main breaker switch), as in this way all the parts to be cleaned will be easily extractable and
replaced. Failure to follow this recommendation will cause the machine to stop in a position that
impedes cleaning and possibly lead to breakage of parts due to poor handling.
 With the stopped machine following the previous process, DISCONNECT the MACHINE of
the POWER SWITCH (Fig. 6). The digital selector display will shut off.
 Remove the cover and wipe it with a damp cloth (ATENTION!: NEVER clean it with
products that can scratch it).
 The tray and blade are removed by unscrewing the nuts on the tray shafts and pulling
outwards horizontally (never extract the set throwing of the blade). Also unscrew the balls
or bevel-headed squeezers that are inside the tray that holds the squeezers (Fig. 15 &
16); underneath each one of them there should be one washer (Fig. 22), be careful not to
lose them! These pieces can be put in the washing machine or cleaned manually. TAKE
EXTRA CARE WITH THE BLADE (Fig. 3) since it is very sharp and may cause injury.
 To remove the cups we recommend that you loosen the fastening screws a little and pull
outwards; they will be released and can then be easily removed.
 WARNING! Do not was the GREY DRIP TRAY (Ref. 0508008G) using hot water or
dishwasher at temperature over 40ºC. In case of distortion of the Drip Tray, this will not be
covered by the guarantee.
Assembly
After everything is washed, put it back in place in the following order:
1 Screw on the balls is the tray that holds the squeezers. Make sure that washers are put
in place beforehand and that the balls are properly tightened.
14