Electrolux ENL62610S Manual De Usuario página 70

70 electrolux
EN
3. Remove any substances in the fi lter
• Open the main tap water valve and
check if water comes out of the Water
Tube.
• Check if the Water Valve is open in
case water does not come out.
• Leave the valve open until clean water
is coming out.
– Initial water may contain
some substances out of fi lter
(manufacturing process).
4. Attach the Filter Box
• Screw and fasten the fi lter holder
to the left/right side of the back of
refrigerator.
– In case the holder is not fastened well,
remove the back paper of the tape on
the fi lter holder and attach it.
• Insert the fi lter box into the holder.
5. Connect the Water Tube to the
refrigerator
• Remove the rear cover at the bottom
back of the refrigerator.
• Insert the fastening ring into the
Water tube. (Be careful to follow the
direction of the nut.)
• Insert the Water Tube into the top
of the Water Valve, turn the nut
clockwise to fasten it. (The Water
valve is to the right of the motors.)
• Check for any bent tubes or water
leaks; if so, re-check installation
procedure.
• Replace the rear cover. (The Water
Tube should be placed between the
groove of the refrigerator back and
motor cover.)
Set the tube upright as the fi gure
shows.
Water
Tube
6. Fasten the Water Tube
• Fasten the Water Tube with the
[Fastener A].
• Check if the tube is bent or sqeezed.
If so, set it right to prevent any water
leak.
Fastener A
Water Tube
7. After installation of Water Supply System
• Plug in the refrigerator, press the
[WATER] button on the control panel
for 2~3 minutes to remove any air
(bubble) in the pipes and drain out the
initial water.
• Check for the water leaks again
through the water supply system
(tubes, connectors and pipes).
Rearrange the tubes again and do not
move the refrigerator.
Water Tube
Water Tube
Nut
Water Valve
Tap
Connector