Sony NUA-BK30 Manual De Instrucciones página 23

Orientation
Always install the IP converter with its
front panel facing up and its
connector panel facing down.
Maintenance
• Clean the unit's surface using
isopropyl alcohol with a
concentration of 50% to 70% v/v or
ethanol with a concentration of
76.9% to 81.4% v/v.
• For stubborn dirt, wipe using a soft
cleaning cloth lightly moistened
with a mild detergent that has been
diluted with water, and then clean
using the previous chemical
cleaning method. Do not use
benzene, thinners, acidic cleaning
solutions, alkaline cleaning
solutions, abrasive cleaning agents,
chemically treated cloths, or other
volatile solvents to clean or
disinfect the unit, as doing so may
damage the unit's surface.
Condensation
If the unit is suddenly taken from a
cold to a warm location, or if ambient
temperature suddenly rises, moisture
may form on the outer surface of the
unit. This is known as condensation. If
condensation occurs, wait until the
condensation clears before using the
unit. Using the unit while
condensation is present may damage
the other connected devices.
Overview
The NUA-BK30 IP Converter Bracket is
an accessory for attaching an IP
converter to the back of a medical-
use monitor.
The IP converter can be attached to a
ceiling suspension arm that conforms
to the VESA standard. This allows an
IP converter and associated cables to
be mounted on a ceiling suspension
monitor in an operating room.
5
Overview
GB