Sony NUA-BK30 Manual De Instrucciones página 27

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 84
4
Remove the cable cover of the
monitor.
0071.ai
5
Connect the cable between the IP
converter and monitor.
6
Connect all the required
communications cables to the
monitor.
Note
When bundling and routing
cables, do not place any
excessive load on the cables.
Attaching the Arm Bracket
1
Align the four M4 screw holes of
the ceiling suspension arm and
the arm bracket, and attach the
bracket using four M4 screws (not
supplied).
Prepare screws of the appropriate
length by referring to
ceiling suspension arm and arm
Cable cover
2
3
"Length of
bracket M4 mounting screws"
(page 16)
.
Hook the groove (A) of the
monitor bracket over the shaft (B)
of the arm bracket.
(A)
Rotate the monitor bracket
around the shaft of the arm
bracket so that the brackets are
slightly open, and secure the
brackets in position using two of
the M4 screws (large) removed in
"Attaching the IP
step 1 of
Converter to the Monitor Bracket"
(page 8)
.
Caution
Secure using the screws before
routing the cables. If cables are
routed without securing the
(B)
9
Mounting
GB

Publicidad

Tabla de contenido
loading

Tabla de contenido