Zoeller STBB200 Manual De Instrucciones página 19

START-UP AND OPERATION
7. Complete the final test of the installation. Be
sure the primary pump is still disconnected from
power. Unplug the controller from the 115V
outlet. Run water into the sump basin until the
backup pump turns on. Check all connections
for leaks.
8. Push the 'Silence' button when the pump is
running to turn off the alarm. The pump will
continue to run for an additional ten seconds
after the float has been lowered or until the
controller senses water is being pumped.
9. Press and hold the 'Silence' button for three
seconds to reset the system and clear all faults
and alarms.
7
8
9
24/7 BASEMENT
1-800-584-8089
BasementSentry.com
19
© 2020. All rights reserved.
Unplug
controller to test
24/7 BASEMENT
PROTECTION
USB
1-800-584-8089
BasementSentry.com
P L U S
AC FLOAT
POWER STATUS
24/7 BASEMENT
PROTECTION
DC
BATTERY
PUMP
USB
1-800-584-8089
DC FUSE
BasementSentry.com
RESET FLOAT PUMP 30 AMP
by
P L U S
AC FLOAT
POWER STATUS
PROTECTION
DC
BATTERY
PUMP
USB
DC POWER
DC FUSE + 15V DC 1.6A
RESET FLOAT PUMP 30 AMP
by
AC FLOAT
POWER STATUS
TEST
DC
BATTERY PUMP
SILENCE
DC FUSE + 15V DC 1.6A DC POWER
RESET FLOAT PUMP 30 AMP
by
Press to
TEST
silence
alarms
SILENCE
DC POWER
+ 15V DC 1.6A
Press and
TEST
hold three
seconds to
reset
SILENCE
system