Tabla de contenido

Publicidad

Step 29
Carefully stand your unit upright.
å
Position your unit in its fi nal location. Turn the ADJUSTABLE FEET (JJ) downward
å
until they touch the fl oor.
IMPORTANT: The ADJUSTABLE FEET should not extend beyond the bottom edges of the
å
SIDE SKIRTS (R).
NOTE: To raise a corner of the unit, turn the ADJUSTABLE GLIDE counter-
å
clockwise. To lower a corner, turn the ADJUSTABLE GLIDE clockwise.
Before fastening the DOOR to your unit, be sure the mounting screw is against the
å
stops as shown in the right diagram. If it isn't, loosen the mounting screw to slide it
against the stops. Then tighten the mounting screw.
Fasten the LARGE DOOR (L) to the LARGE END (B) as shown in the lower
å
diagram. Use the screws in the HINGES. You should start each SCREW a few turns
before completely tightening any of them.
Fasten a PULL (X) to the LARGE DOOR (L). Use two BLACK 7/8" MACHINE
å
SCREWS (NN).
See the next step for DOOR adjustments.
å
Stop
Mounting
screw
BLACK 7/8" MACHINE SCREW
(2 used for the PULL)
Turn the ADJUSTABLE FEET
downward until it touches the fl oor.
www.sauder.com/services
Hinge
NN
Floor
JJ
R
411965
LARGE DOOR ON RIGHT
B
L
X
Page 33

Publicidad

Tabla de contenido
loading

Tabla de contenido