Screen Configuration; Setting The Day Of The Week And Time; Operation; Turning On/Off - Mitsubishi Electric CITY MULTI PKFY Serie Manual De Instrucciones

3. Screen Configuration
Function Selection of remote controller
A
Standard Control Screens
OFF
B
Timer Monitor
MON
TIMER
OFF
˚F
WEEKLY
4. Setting the Day of the Week and Time
TIME SUN
˚F
TEMP.
MENU ON/OFF
BACK MONITOR/SET DAY
PAR-21MAA CLOCK
Note:
The day and time will not appear if clock use has been disabled at
Function Selection of remote controller.

5. Operation

5.1. Turning ON/OFF

<To Start Operation>
Press the ON/OFF button .
• The ON lamp and the display area come on.
Note:
When the unit is restarted, initial settings are as follows.
Remote Controller settings
Mode Last operation mode
Temperature setting Last set temperature
Fan speed Last set fan speed
Airflow up/down
Mode
*1 Last setting might be applied depending on the type of the indoor
unit.
*2 In case of the last setting is swing, airflow might be Downward 4
depending on the type of the indoor unit.
6
Set Day/Time
TIME SUN
D C
˚F
˚F
O N
C
Timer Setup
SUN MON TUE WED THU FRI SAT
B
Day of the Week &
Time display
˚F
ON/OFF
FILTER
CHECK TEST
OPERATION
CLEAR
˚F
˚F
COOL or DRY Horiz. outlet *1
HEAT Last setting *2
FAN Horiz. outlet *1
<Screen Types>
For details on setting the language for the remote controller display, refer
to section 8. Function Selection.
The initial language setting is English.
Function Selection of remote controller:
Set Day/Time:
Standard Control Screens:
Timer Monitor:
Timer Setup:
<How to change the screen>
: Hold down both the Mode button and the Timer On/Off button for 2
A
seconds.
: Press the Timer Menu button.
B
: Press the Operation mode (Back) button.
C
WEEKLY
: Press either of the Set Time buttons (
D
1. Press the or
2. Press the Timer On/Off (Set Day) button
* Each press advances the day shown at
Sun Mon ...
3. Press the appropriate Set Time button 1 as necessary to set the time.
* As you hold the button down, the time (at
one-minute intervals, then in ten-minute intervals, and then in one-hour
intervals.
4. After making the appropriate settings at Steps 2 and 3, press the Filter
button to lock in the values.
4
2
5
6
1
2
<To Stop Operation>
Press the ON/OFF button
• The ON lamp
1
Note:
Even if you press the ON/OFF button immediately after shutting down
the operation is progress, the air conditioner will not start for about
three minutes. This is to prevent the internal components from being
damaged.
Set the functions and ranges available to the
remote controller (timer functions, operating
restrictions, etc.)
Set the current day of the week or time.
View and set the air conditioning system's operat-
ing status.
View the currently set timer (weekly timer, simple
timer or Auto Off timer).
Set the operation of any of the timers (weekly
timer, simple timer or Auto Off timer).
or ).
Day of the Week Setting
TIME SUN
Time Setting
Set Time button 1 to show display
to set the day.
:
3
Fri Sat.
) will increment first in
4
˚F
again.
1
and the display area go dark.
.
2
3
7
3
5
6
7