Adjusting The Bending Angle; Maintenance And Cleaning; Monthly Cleaning - Abicor Binzel WH Instructivo De Servicio

Alignment jig

6.2 Adjusting the Bending Angle

Material damage
The torch neck can be damaged in case of too frequent and excessive bending.
• Perform only minor corrections.
1
2
Fig. 5
1 Plug on/screw in the adjusting sleeve (3) onto the gas nozzle receptacle.
2 Put the adjusting lever (4) onto the adjusting sleeve (3) and correct the bending angle slightly.
Check the concentricity of test mandrel (1) and measuring sleeve (2) constantly during this procedure.
The bending angle is correct if the test mandrel (1) fits easily into the bore of the measuring sleeve (2).

7 Maintenance and cleaning

Scheduled maintenance and cleaning is a prerequisite for a long life and a trouble-free operation.

7.1 Monthly cleaning

A monthly basic cleaning is recommended, and necessary in case of extreme working conditions.
CAUTION
1
Test mandrel
Measuring sleeve
Adjusting
7 Maintenance and cleaning
2 3
3 Adjusting sleeve
4 Adjusting lever
4
EN - 9