Mutsy NEXO Manual De Instrucciones página 25

The baby position (0 to 6 months) (t)
Infants younger than 6 months must be strolled in a flat fully reclined
position. To do so, you must set the pram seat in the baby position. This
position makes the reclining angle flat and ensures more comfort and
safety. The baby position has four aspects:
· The seat needs to be set into the flat fully reclined position; A double
strap is located at both sides of the seat. Pull the outer strap down-
wards until the top press-stud (t1) is visible. Push the seat slightly high-
er to create more room. Now fasten the press-stud. The seat is now in
the reclined position.
· The backrest must be set in the fully reclined position. See 'Adjusting
the backrest' .
· The padded crotch strap of the safety belt must be mounted in the rear
opening of the seat. See 'The 5-point safety belt' .
· The shoulder straps must be mounted in the under most openings of
the backrest. See 'The 5-point safety belt' .
The pram seat must be removed from the baby position for infants from
6 months and up to 15 kg.
· The seat needs to be set be set into the sitting position. Pull the outer
strap partially out of the upholstery to loosen the press-stud (t2). Loos-
en the press-stud. Push the seat down completely.
· The backrest can be set to any desirable position. See 'Adjusting the
backrest' .
· The padded crotch strap of the safety belt must be mounted in the
foremost opening of the seat. See 'The 5-point safety belt' .
· The shoulder straps must be mounted in one of the top three pairs of
openings of the backrest. See 'The 5-point safety belt' .
Adjust the back support (m)
· The button for adjusting the back support is located at the rear of the
back support.
· Pinch the button and continue pressing it while moving the back sup-
port backwards to lower the back support. Release the button when
the back support has reached the desired position.
· Pinch the button and continue pressing it while moving the back sup-
port forwards to bring the back support in an upright position. Release
the button when the back support has reached the desired position.
Adjust the leg support (n)
· Lift the leg support to place it upwards.
· Pull the tube (n1) at the bottom of the leg rest to lower it again.
20