Mutsy NEXO Manual De Instrucciones página 26

Attach and remove bumper bar (o)
· To secure the front bumper, press the ends of the bumper into the re-
cesses (o1) intended for this purpose on the frame until you hear a click.
· Press the unlock buttons (o2) on the inside of the bumper bar to re-
move the bumper bar from the frame.
Place the hood (p)
· Press the clips of the hood on the correct location on the frame. The
hood is fixed on the tubes of the frame. (p1)
· Subsequently, attach the fabric of the hood to the top of the back sup-
port using the studs. (p2)
Adjust the hood (q)
· Hold the front hood bar in the centre and move it forwards or rear-
wards to adjust the hood (q1)
· Open the zipper in the centre of the opened hood in order to enlarge
it. (q2)
· Close the zipper to again reduce the hood.
· Pull the flap on the front side of the hood outwards to additionally en-
large the hood. Push the flap inwards to again reduce the hood.
Remove the hood (r)
· Release the studs at the top of the seat (r1). Then press the lip (r2) at the
bottom of the clips of the hood inwards and remove the hood.
Assemble the rain cover on the pushchair (s)
· Make sure that the hood of the pushchair is in the upright position.
· Possibly open the zipper in the rain cover to adapt it to the enlarged
hood of the pushchair.
· Place the rain cover from top to bottom over the pushchair and make
sure that the rain cover is attached well behind the back support and
over the footrest.
The 5-point safety harness (u)
· Place your child in the pushchair and make sure that the legs of your
child are placed on each side of the leg piece.
· Make sure that the hip and shoulder belt is positioned correctly over
your child and place both plastic clamps in the central part of the har-
ness attached to the leg piece.
· In order to adapt the length of the shoulder belts, you release the
shoulder protection from the belt by pulling the Velcro loose. The straps
of the belt are now free in order to adapt the length. You adapt the
EN
21