CESVA SC202 Manual Del Usuario página 133

Ocultar thumbs Ver también para SC202:
Tabla de contenido

Publicidad

PÁRRAFO
DESCRIPCIÓN
IEC 61260
7.2 b)
Linear operating range and level linearity
acceptance limits, of output signal levels
outside
7.2 c)
The maximum root-mean-square value of a
sinusoidal input signal at any frequency in the
range of the instrument
7.2 d)
Recommendations on operation of the
instrument to ensure that measurements are
made within the linear operating range
7.2. e)
For each nominal filter bandwith available, the
range of nominal mid-band frequencies for
time-invariant operation and other information
pertinent to spectral analyses of transient and
time-varying signals
7.2. f)
The operation and interpretation of overload
indications.
7.2 g)
Range of relative humidity and corresponding
air temperature over which the instrument can
operate without exceeding the requirements.
7.2 h)
The recommender means to check that the
electrical power supplied is sufficient to
operate the instrument
7.2 i)
The identification of the specific instrument
7.2 k)
The maximum time needed after switching on
the instrument before the instrument may be
used to mesure filtered output signal levels
7.3
Testing
7.3 a)
Reference level range
7.3 b)
Reference input signal level and
corresponding reference value
7.3 c)
Any adjustment procedures that are required
to verify the reference attenuation
7.3 d)
If required, the real and reactive components
of the terminating impedances that should be
placed at the input and output
7.3 e)
The effect of any short circuit applied to the
analogue output of a band-pass filter
7.3 f)
The configuration of the instrument for the
normal mode of operation
7.3 g)
Any specific degradation in performance or
loss of functionality following the application
of electrostatic discharges
Capítulo 25
Referencia a normas
SECCIÓN Manual SC202
20.2.1 Modelos de micrófono y sus características
principales
20.5.1 Filtros de bandas de octava y tercio de octava
11.4 Indicador de sobrecarga (overload)
20.6.2 Criterios ambientales
7 Alimentación
3.3 Partes del equipo
20.6.1 Tiempo de estabilización
20.2 MICRÓFONO
20.2 MICRÓFONO
20.2 MICRÓFONO
20.2 MICRÓFONO
15 Configuración y ajustes
20.6 CRITERIOS AMBIENTALES
ELECTROSTÁTICOS Y DE RADIOFRECUENCIA
131

Publicidad

Tabla de contenido
loading

Tabla de contenido