Uline OHAUS RANGER H-9554 Manual Del Usuario página 21

CONNECTIONS FOR RS232
The 9-pin female subminiature "D" connector COM1,
is provided for interfacing to other devices. The pin
connections are as follows:
Active pins: PIN 2 = TXD, PIN 3 = RXD, PIN 5 = Ground
Figure 7
5 4
9
PRINTOUTS
The following sample print outs are generated by the
Print button, "P" Command or alternate print command.
The content of the printout is defined in the Print Content
menu item.
DESCRIPTION
Part Number Line If Printx > Content > P/N is on
Result line If Printx > Content > Result is on
If Printx > Content > Gross is on and a tare
Gross value line
value is entered
If Printx > Content > Net is on and a tare
Net value line
value is entered
If Printx > Content > Tare is on and a tare
Tare value line
value is entered
APW line If Printx > Content > APW is on
Accumulation line If Printx > Content > Accu is All
OUTPUT FORMAT
The printout string has a fixed length of 22 characters for
most applications except check weighing. For check
weighing mode, the printout string has a fixed length of
29 characters.
CHECK WEIGHING APPLICATION
FIELD
Weight
(right aligned)
Space
Unit
(right aligned)
Space
Stability (?)
Space
PAGE 21 OF 69
TECHNICAL DATA CONTINUED
3 2 1
8 7 6
COMMENT
LENGTH
11
1
5
1
1
1
FIELD
T/N/G/PT
(right aligned)
Space
Application Status
(right aligned)
Term.
NON-CHECK WEIGHING APPLICATION
FIELD
Weight
(right aligned)
Space
Unit
(right aligned)
Space
Stability (?)
Space
T/N/G/PT
(right aligned)
Term.
Each field is followed by a single delimiting space
(ASCII: 32).
DEFINITIONS
• Weight – Up to 11 characters, right justified, at
immediate left of most significant character
(if negative).
• Unit – Up to five characters, right justified. If the Unit
in the Print Content menu was set to off, the unit will
be removed in the weight string and replaced by
spaces.
• Stability – "?" character is printed if not stable. If
weight is stable a space is printed.
• T/N/G/PT – "T" is printed for a tare weight, "N" printed if
weight is net weight, "G" or nothing printed if weight
is a gross weight, "PT" is printed if the tare weight is
Pre-set Tare.
• Application Status (for Check) – Fixed to six
characters. Display status like "Under", "Accept" and
"Over" for check weighing.
• Terminating Character(s) – terminating character(s)
printed depending on FEED menu setting.
LENGTH
2
1
6
2
LENGTH
11
1
5
1
1
1
2
2
1021 IH-9554