Connect The Unit - Oase Vitronic 9 Instrucciones De Uso

- English - - English -
Installation
Important:
● Only install the unit in the permitted positions to ensure fault-
free operation.
● Do not lift by its power cord.
● Install the unit at least 6.6 ft (2 m) from the edge of the pond.
● Allow sufficient space for carrying out maintenance work.
Mounting the unit - optional
●
For the Vitronic 9W, the unit head is removed
first. (See P.7 for Removing the unit head)
1. Place the unit on the mounting surface.
○ Carefully tighten all screws.
● After mounting the Vitronic 9W, reconnect the
unit head. (See P.7 for Fitting the unit head)

Connect the unit

● Use hoses that are suitable for a pressure of at least
14.5 psi (1 bar).
1. For maximum water flow, it is recommended that the
largest tubing size for your pump is used.
○ If needed, cut the adapter as shown using a hacksaw;
consult packaging for tubing size.
2. Connect the stepped hose adapter with seal to the casing.
○ Connect the inlet and outlet.
○ Hand tighten the stepped hose adapter.
3. Connect tubing to the adapter. Secure with a hose clamp.
○ In the case of a stepped hose adapter with separate
union nut, first push the union nut over the hose.
NOTE: Tubing is NOT INCLUDED.
1.
Vitronic 9W
1.
2.
Vitronic 9W
Vitronic 18W / 36W
3.
Vitronic 18W / 36W
4