Use Of Cooling Function - oneConcept Air Cube Manual De Instrucciones

EN
16

USE OF COOLING FUNCTION

1. When using the appliance, make sure that it is on a flat and stable surface.
Damage may occur if it is placed on an incline or decline. If you need cooler
more, add ice block into upper water slot, see following image:
Note: the ice box should be far way from children to avoid eating.
2. Insert the plug directly into a standard AC 220-240V socket-outlet. Be
sure plug fits tightly into outlet.
3. POWER button
Press the button POWER to start the fan.
4. Press the COLD button.
Note: Do not use this button without water, to avoid damage to parts. Press
the button, the water pump start to work, the wind will be cooler and wet.
• Before operating the unit in Cold mode, make sure the escape valve for
the water tank is properly fixed. Then proceed to add clean water into the
water tank. While adding the water, make sure that you keep an eye on the
water level indicator to make sure that you do not OVER or UNDER FILL
the unit. Press the button Cold after you have added the water and the
unit should commence to blow cooler air. When you press the button Cold
again, it will stop working.
• If you find that the air after Step 1) is still not cold enough, you can add
additional ice block into the water tank directly by opening the water tank
cover. Be sure not to exceed the icebox capacity otherwise damage to the
unit or electric shock may occur.
A Rotate the small knob.
B Pull out the water tank.
A
C Add the water from here into
C
water tank.
D Put ice box into the water
tank.
D
B