Use And Operation; Controls And Functions - oneConcept 10030880 Manual De Instrucciones

1. When using the appliance, make sure that it is on a flat and stable surface. Damage may occur if it
is placed on an incline or decline. If you need cooler more, add ice block into upper water slot, see
following image. Note: the ice box should be far way from children to avoid eating.
2. Insert the plug directly into a standard AC socket-outlet. Be sure plug fits tightly into outlet. Turn
on the mechanism switch. Now the power pilot light will light on.
ON/OFF Press the button ON/OFF to start the fan. Note: the default fan speed and fan
mode is Medium and Normal when press ON/OFF one time.
SPEED Press the SPEED button to set the desired fan speed (Low/ Medium/ High).
As per the following sequence: MI > HI > LO > MI. The fan speed selecting can
be circulated and the speed pilot lamp will be on during the fan operating.
UP/DOWN
If you want to enlarge blast area in your room, press the vane button, the fan
will blast your room in large scope. Press the „UP DOWN VANE„ button once or
more, set up the outlet starting page or stop swinging around air supply, at the
same time corresponding instructions icon light or go out.
LEFT/RIGHT If you want to enlarge blast area in your room, press the vane button, the fan
will blast your room in large scope. Press the „LEFT RIGHT VANE„ button once or
more, outlet yawing page starting or stopping air supply bobbing left and right,
and the corresponding instructions icon light or go out.
TIMER Set the time by pressing the timer button to select a desired timing level as fol-
low, the range is between 1-15 hours. The pilot light corresponding to the selec-
ted timing level will be illuminated.
MODE
The default setting is Normal wind, and then you can press the button Mode again
to choose your desired wind mode as per the following sequence: NORMAL >
NATURAL > SLEEP.

Use and Operation

Controls and Functions

9