How To Initialise The Setting - JVC TM-2100PN Instrucciones

HOW TO INITIALISE THE
SETTING
SCREEN DISPLAY AND SELECTIONS IN THE
<SET-UP MENU> RESET MODE
You can set <MENU> and <SET-UP MENU> screen items, picture adjustment items and
the volume level to their factory-set (initial) values.
1. Press the Power (
—
OFF ( ).
ON
OFF
POWER
2. While pressing both MENU button and PHASE (
button, press the Power (
_
ON ( ).
_ON
—OFF
POWER
PHASE MENU
3. Setting
Initialisation is required.
CONTRAST
Initialisation is not required.
– +
VOLUME/SELECT
10
LCT0053-002A-H (EN)
) Switch to turn the power
) switch to turn the power
The <SET-UP MENU> RESET screen is displayed.
Note:
● The <SET-UP MENU> PRESET screen will not be
displayed if the MENU or PHASE buttons are pressed
for a very short time. Keep pressing them until the
display screen appears.
Press the CONTRAST (
* Initialisation is completed, and the <SET-UP MENU>
RESET screen disappears.
Press the VOLUME/SELECT [+] or [–] button.
* Initialisation is aborted, and the <SET-UP MENU>
RESET screen disappears.
10
)
) button.
02.07.30, 2:46 PM
<SET-UP MENU> RESET screen
<SET–UP MENU> RESET
Are you sure ?
"Yes" then <CONTRAST>
"No" then <+> or <–>
Initial settings
Initialisation
Functions (Items)
(setting)
SHARPNESS 00
COLOR TEMP. 6500
COLOR SYSTEM AUTO
ASPECT RATIO 4–3
BRIGHTNESS P.S. OFF
H. POSITION 00
V. POSITION 00
WHITE BALANCE
R. CUT OFF 00
G. CUT OFF 00
B. CUT OFF 00
R. DRIVE 00
G. DRIVE 00
B. DRIVE 00
CONTROL LOCK OFF
B.P.S. LEVEL 10
REMOTE SELECT OFF
PHASE 00
CHROMA 00
CONTRAST 00
BRIGHT 00
VOLUME 20